Electrical Connection; Control Panel Description - Whirlpool ACM 723 Mode D'emploi

ELECTRICAL CONNECTION

WARNING
- The manufacturer declines any liability for injury to persons and animals or damage in case of failure to comply with the instructions provided in this
section.
- The power cable must be long enough to allow the hob to be removed from the worktop.
- Make sure the voltage specified on the dataplate located on the bottom of the appliance is the same as that of the home.
- Do not use extension cords.
Connection to the terminal block
For the electrical connection, use an H05RR-F cable as specified in the table below.
Wires
230 V ~ +
230-240 V ~ +
230 V 3 ~ +
400 V 3N ~ +
400 V 2N ~ +
A B
Connect the yellow/green earth wire to the terminal with the symbol
This wire must be longer than the other wires.
1. Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B).
2. Insert the power cable in the cable clamp and connect the wires to the terminal block as indicated in the connection diagram located near it.
3. Secure the power cable with the cable clamp.
4. Close the cover (C) and screw it on the terminal block with the removed screw - point (1).
Each time the power is connected, the hob performs an automatic check for a few seconds.
If the hob already has a power cable, follow the instructions attached to the cable. Connect the appliance to the power supply by means of a multipole switch with minimum
contact gap of 3mm.
NOTE: When using the hob for the first time, please take care not to have powerful halogen lights, like those of a hood, shining over the sensor button area of the hob. These
lights may interfere with the starting of the system.
INSTRUCTIONS FOR USE

Control Panel Description

The panel has touch controls: to use them, just press the corresponding symbol (a light touch is sufficient).
- Disconnect the appliance from the power supply.
- Installation must be carried out by qualified personnel who know the current safety and installation
regulations.
Number x size
3 x 4 mm2
3 X 4 mm2 (Australia only)
4 x 1.5 mm2
5 x 1.5 mm2
4 x 1.5 mm2
C
On/Off
Cooking zone buttons and corresponding display
400 V 3N ~
400 V 2N ~
.
Timer
Key lock
GB7
230-240 V ~ (Australia only)
230 V ~
230 V ~ (UK only)
230 V 3 ~ (Belgium only) 400 V 2N ~ (NL only)