Etherma LAVA LITE Instructions D'installation Et D'utilisation page 10

W A L L M O U N T I N G
INSTALLING THE DESIGN INFRARED HEATING:
Please inspect the power supply cord to the heater and the
surface before installation. These must not show any signs of
damage.
1. Using the appropriate screws, position the bracket on the
wall, with the larger holes on the upper side (see image).
2. Align the bracket in the desired location, and mark the drill
holes on the wall. Now, drill the six holes.
3. Before mounting the bracket, you will need to run the power
cord out of the wall and along the top or bottom of the brack-
et so that you can then connect the device in the next step.
4. You can now secure the bracket using the appropriate screws.
(The appropriate screws will depend on the type of wall.)
5. You can now connect the device and slide it into the bracket.
TIP:
First clip the device into position on one side before doing the
same on the other side. Then, press the device lightly onto the
bracket and slide it first to the right then downward (specified
insertion from the keyhole).
10
ATTENTION: Screws and dowels are not included
in the scope of delivery and must correspond to the
construction material of the wall.
ATTENTION: The LAVA LITE infrared heating must
®
not be mounted directly beneath a wall socket.