Description Of Appliance And Accessories; Preliminary Phases Before Use - Imetec H1701 Mode D'emploi

GB
DESCRIPTION OF APPLIANCE AND ACCESSORIES [Fig. A]
1. Lid
2. Electronic LED
3. Filling hatch
4. Filtering cartridge
5. Pre-filtering container
6. Jug

PRELIMINARY PHASES BEFORE USE

Open the packaging and unpack the components: lid (1), pre-filtering container (5) and
jug (6).
Wash the pre-filtering container (5) and the jug (6):
by hand, with water and delicate, non-abrasive detergents;
in the dishwasher, making sure the water's maximum temperature does not exceed
50°C.
Wash the lid (1):
by hand, with water and delicate, non-abrasive detergents, paying attention not to
introduce the electronic LED into the water (2);
dry with a clean, dry cloth.
ACTIVATION OF THE ELECTRONIC LED
Remove the lid (1) from the jug (6).
Press the electronic LED "RESET" button (2) until all four black notches appear [Fig B].
Insert the lid (1) onto the jug (6), the electronic LED (2) will activate automatically [Fig
F].
PREPARING THE FILTERING CARTRIDGE
Remove the filtering cartridge (4) from the package and shake it for about 10 seconds.
Immerse the filtering cartridge completely (4) in a container of cold water for about 15
minutes, shaking it now and again to remove any air bubbles it may contain [Fig C].
Insert the filtering cartridge (4) inside the pre-filtering container (5) making sure it
adheres perfectly to the edges [Fig D].
Insert the pre-filtering container (5) into the jug (6) [Fig E].
Insert the lid (1) onto the jug (6) [Fig F].
ACTIVATING THE FILTERING CARTRIDGE
Fill the pre-filtering container with water (5) through the filling hatch (3) [Fig G].
Allow water to flow into the jug (6) through the filtering cartridge (4). The operation may
require from three to five minutes [Fig H].
Empty the filtered water contained in the jug (6)into the sink [Fig I].
Repeat the previous operations relative to the activation of the filtering cartridge
another two times.
11