Querying The Code Numbers - Ruwido easytip S4 Mode D'emploi

3. Enter code 001 (code search) with the number keys. The LED blinks twice.
4. Manual operation: Keep pressing the Power/Standby-key at short intervals until your
device shows reaction.
Automatic operation: Press the Power/Standby-key until your device shows reaction.
Every 1.5 seconds the TV code is continued automatically and the appropriate standby
command is sent.
When your easytip S4 has found the right code your device switches off and you can
then release the Power/Standby-key.
5. Now press the Level key again until the LED
blinks twice.
This shows you that your easytip S4 has stored the appropriate code number.
6. Now check the function of your remote control. If your easytip S4 does not react to the
code number it has found, repeat steps 1 to 5 until you have found a optimal code
number.
ATTENTION!
A new code search begins with the last code number found in the previous search. When
the end of the code list is reached the LED will blink three times. The search is then repea-
ted from the beginning. Please be patient. There may be many codes to search through
before the code for your equipment is found.
Changing the direction or the search:
It is possible, particularly in automatic search mode, to skip over the relevant code by
mistake. In this case, you can reverse the direction of the search for a maximum of 5
codes by pressing the Vol-key.
ATTENTION!
After 5 codes the search direction changes back automatically.
If you want, you can press the Vol+-key to change back to the original search direction.
Adjusting color, contrast, bass, treble...
for your TV set
1. Press the Level key.
2. Briefly press the Shift-key.
3. Press the chosen key within 5 seconds.
Numberkey 1 = Brightness
Numberkey 2 = Color
Numberkey 3 = Contrast
Numberkey 4 = Treble
Numberkey 5 = Bass
Numberkey 6 = Balance
4. You can adjust your device by using keys Vol- and Vol+.
5. After the end of adjusting, wait for about 5 seconds until the keys get back their normal
function.

Querying the Code Numbers

You will need this function to query the code found by the automatic code search, so that
you can note it down in this operating manual.
1. Press the chosen Level key (TV, SAT, AUX) until the LED blinks twice.
2. Now enter code 002 for query mode.
ATTENTION!
The first figure of the 3-digit code must be entered within 5 seconds of the LED blinking
twice.
Otherwise the LED will flash once and you will have to repeat the procedure from step 1.
3. Now press key 1 and count the number of times the LED blinks. (For example, if the
LED blinks twice the first number in your code is 2).
Now press key 2 and count the times the times the LED blinks. (For example, if the
LED does not blink, the second number in your code is 0).
Now press key 3 and count the times the LED
blinks. (For example, if the LED blinks seven times, the third number in your code is 7).
Your code number would therefore be 207.
4