Kenwood Mini 1150 rapid Mode D'emploi page 87

Press buttons:
• These buttons must be activated, after having selected a programme.
• Once a button has been pressed, it takes 15 sec for it to be activated, this process is shown on
the digital display in 5 segments lasting 3 sec each every time a button is pressed, this process is
repeated.
Attention:
Once the 15 sec. have passed, and the programme has started it is no longer possible to change the
programme by means of the press buttons.
The selected programme and temperature are shown alternatively on the digital display.
Attention:
As soon as a wash cycle is started, the selected temperature is stored in the machines computer.
Therefore, if you change the temperature after the wash cycle has started, the machine will not
respond.
Should you wish to change the temperature during a wash cycle, please carry out the following
procedure.
• Switch the programme selector to position "".
--> See programme "override" page 89
• Wait until the digital display showing " 00 " stops flashing
• Select programme with correct temperature, and start again.
Programme selection
87