8 Settings On The Microphone Cs-W4T; Operation; 1 Receiver Cs-W4C - Monacor International JTS CS-W4C/5 Mode D'emploi

Speakers using channels with priority (
) will be able to interrupt speakers
ority Yes
using channels without priority provided that
the volume of speech of the speaker interrupt-
ing other speakers exceeds the volume set as
the
Threshold
have been set to
nels can be simultaneously used for speaking
4.8 Settings on the microphone
CS-W4T
If required, settings of the wireless microphone
CS-W4T can be directly made on the microphone
The ID number required for REMOSET transmis-
sion can only be set on the microphone
1) To switch on the microphone, move the sliding
switch (22) to the position ON
The display (25) shows the transmission fre-
quency currently set or the group and the
channel When the group or channel is shown,
keep one of the buttons
show the corresponding frequency
2) To call up the setting menu, keep the button
SET (28) pressed for approx 2 seconds until
appears on the display
3) Briefly press the button SET to go to the next
parameter of the menu
4) The parameter that can currently be set starts
flashing To change the setting, use the but-
tons (27) and then press SET to go to the
 
next parameter
5) When the end of the menu has been reached
and the button SET is pressed, the menu will
be exited
When a change has been made,
briefly appear on the display; when no change
has been made,
The following setting options are available:
Menu item
...
(Example)
MHZ
⁄
⁄
⁄
32
value When multiple channels
, these chan-
Priority Yes
(27) pressed to
 
will briefly appear
Setting
Group – channel
Transmission frequency
Microphone sensitivity
Transmission power
10 / 50 mW
High pass filter off / on
Pri-
Menu item
Fig. 32 Setting option on CS-W4T

5 Operation

5.1 Receiver CS-W4C

5.1.1 Switching on /off the receiver,
indications on the display
1) Use the button
The display (3) will show the status of the four
receiver sections (as in fig 1) The following
warning messages may periodically be shown:
No Signal
off or uses a different transmission frequency
than the receiver (chapter 4 5)
Mic.Mute
(not available for CS-W4T)
Low Battery
transmitter are almost discharged
2) The display can show the following informa-
tion:
Indication Meaning
left side of the display
AT
separately for each of the four receiver sections
will
3
AT
ID
G
CH
Setting
Identification number for
the REMOSET function
⁄ REMOSET reception off / on
(4) to switch on the receiver
= The transmitter is switched
= The transmitter is muted
= The batteries of the
Key lock activated
Operating voltage for antenna am-
plifiers connected is switched on
The output MIXED AF OUTPUT (20)
has been set to microphone level
Number of the receiver section (1– 4)
Priority has been assigned to the
receiver section (
Priority
The signal output CH (21) has
been set to microphone level
Indication which of the two anten-
nas (A or B) receives the radio signal
of higher strength; when no signal
is received, × will be shown
Identification number for
the REMOSET function
Group number (1... 6, U1...U6)
Channel number (1... 24)
)