Monacor International JTS CS-W4C/5 Mode D'emploi page 21

ANT. A
14 15 16
Fig. 2 Rear panel of CS-W4C
22
23
24
25
26
28
Fig. 3 CS-W4T
When the menu is called up
– Turn the knob to select a menu item or
change a setting
– Press the knob to call up a menu item
8 Button EXIT to exit the menu or a submenu
9 Button to activate the key lock
(keep the button pressed for 1 second until
appears on the left of the display)
To deactivate the key lock, keep the button
pressed for 2 seconds until
10 RF indicators to indicate reception of a radio
signal, one each for the receiver sections
CH1– CH4
11 AF indicators, one each for the receiver sec-
tions CH1– CH4
The indicator will light up when the corre-
sponding microphone is used for speaking and
when the signal of this microphone is not sup-
pressed by the signal of another microphone
When the automatic mixing function has been
deactivated, the indicator will light up as soon
as a radio signal is being received
12 Button SET to select the receiver section
– whose settings are to be changed: When
the receiver section has been selected, call
up the setting menu by means of the button
SETUP (6)
VOLTAGE OUTPUT
MIXED
AF OUTPUT
4 3 2 1 GND
UNBALANCED
cascade A
LINK IN LINK OUT
17 18 19
CS-W4T
27
SET
29
disappears
CH4
AF OUTPUT AF OUTPUT
BALANCED BALANCED BALANCED
20
– whose settings are to be transferred to the
corresponding transmitter: When the re-
ceiver section has been selected, press the
button REMOSET (5)
13 Buttons
 
responding receiver section
14 Jack for connection to a mains socket (230 V/
50 Hz) via the mains cable provided
15 Power supply jack to connect another receiver
(chapter 4 1 1)
16 BNC jacks for the antennas provided
17 Antenna signal outputs to connect another
receiver (chapter 4 1 1)
18 Screw terminals VOLTAGE OUTPUT to control
external status indicators, for example (chapter
4 1 2)
19 Jacks LINK IN and LINK OUT to interconnect
multiple receivers CS-W4C (chapter 4 1 1)
20 Audio outputs (XLR jack and 6 3 mm jack) with
the mixed signal of the four receiver sections
and the mixed signal of a receiver connected
via the jack LINK IN (19) (line level or micro-
phone level can be selected)
21 XLR audio outputs (line level or microphone
level can be selected) of the receiver sections
CH1– CH4
1.2 Wireless microphone CS-W4T
22 On /off switch
OFF: microphone switched off
ON: microphone switched on
LOCK: microphone switched on, setting menu
locked
23 Lockable mini XLR jack for the gooseneck
microphone
24 Power LED indicator
red: normal operation
blue: REMOSET reception active
25 Display
26 LED indicator to indicate that the microphone
can be used for speaking
27 Buttons
 
28 Button SET to call up the setting menu
29 Talk button to activate / deactivate the micro-
phone for speaking
CH3 CH2 CH1
AF OUTPUT AF OUTPUT
BALANCED BALANCED
21 17
to adjust the volume of the cor-
for the setting menu
cascade B ANT. B
16
21