2 Connections On Cs-W4T; 3 Settings Via The Menu - Monacor International JTS CS-W4C/5 Mode D'emploi

Fig. 6 Example with relay

4.2 Connections on CS-W4T

4.2.1 Gooseneck microphone
Connect the gooseneck microphone provided to
the mini XLR jack (23) of CS-W4T; then tighten
the nut to secure the microphone
Place the foam windshield provided onto the
microphone cartridge to suppress pop noise and
to protect the microphone from the moisture
from your breath
4.2.2 Power supply
Two non-rechargeable batteries or two recharge-
able NiMH batteries (AA) supply CS-W4T with
power To insert the batteries, open the battery
compartment on the lower side of the unit and
insert the batteries as indicated in the compart-
ment Then close the compartment
1.System Options
2.User Group
3.Priority
4.CH1
5.CH2
6.CH3
7.CH4
8.Exit
Fig. 7 Setting menu
NiMH batteries can be recharged when they
are inserted in CS-W4T Two chargers are avail-
able:
W4-CH1: Charger for a single microphone
W4-CH12: Transport case with charging function

4.3 Settings via the menu

1) To call up the menu (fig 7), keep the button
SETUP (6) pressed for 2 seconds until the menu
appears on the display (3)
2) Turn the knob PUSH / CONTROL (7) to select
the desired menu item Then press the knob
to call up the menu item
3) Turn the knob to make the setting or, when a
submenu appears, turn the knob to select a
submenu item and press the knob to call it up
To exit a submenu, use the line
press the button EXIT (8)
4) If multiple setup functions are available for a
menu item (e g group number and channel
number), press the knob to go from one func-
tion to the next one
5) To save a setting, press the button SETUP The
display briefly shows
vious menu reappears
1.Display Options
2.Indicator
3.Antenna Power
4.Mixed Output Level
5.Reset
6.Return
1.Frequency
2.Group/Channel
3.Scan
4.Squelch
5.Remoset ID
6.Output Level
7.Mic Config
8.Return
for up to 12 microphones
Saving
1.Edit
2.Clear Group
3.Return
Bypass
Threshold
Rx1 Priority Yes
Rx2 Priority No
Rx3 Priority No
Rx4 Priority No
Delay Time
Return
1.Mic.Sensitivity
2.Mic.Attenuate (TB)
3.Mic.Low Cut
4.Mic.RF Power
5.Mic.Auto OFF
6.Mic.KeyLock
7.Remoset Config
8.Return
or
Return
before the pre-
No
-50 dB
3 Sec
25