6 Separate Settings For The Four Receiver Sections - Monacor International JTS CS-W4C/5 Mode D'emploi

2 For each transmitter separately
It is recommended to transfer the settings sepa-
rately for each transmitter when the settings for
a single transmitter are to be changed or when
simultaneous synchronization of four transmitters
has failed
1) Press the button SET (12) of the corresponding
receiver section On the display, the field of the
receiver section is highlighted
2) Press the button REMOSET; only the settings
of the receiver section selected are transferred
to the corresponding transmitter
4.6 Separate settings for the
four receiver sections
The menus of the receiver sections (fig 27) can-
not only be used to set the frequency and the
channel, but also to set the output level and
the interference suppression (squelch) In ad-
dition, the corresponding transmitters can be
most conveniently set by means of menu item
7.Mic Config
To call up the menu for a specific receiver section,
either
– press the button SET (12) for the receiver section
desired (on the display, the field of the receiver
section is highlighted) and then keep the button
SETUP (6) pressed until the menu is shown or
– keep the button SETUP pressed until the menu
with the line
1.System Options
Use the button PUSH / CONTROL (7) to select
the receiver section CH1 – 4 and then press the
button to call up the setting menu
1.Frequency
2.Group/Channel
3.Scan
4.Squelch
5.Remoset ID
6.Output Level
7.Mic Config
4.6.1 Output levels Line or Mic
The menu item
6.Output Level
to separately set each of the individual audio out-
puts CH1– CH4 (21) to line level or microphone
level
Setup Ouput Level
Line
Mic.
30
(fig 30)
Fig. 27
can be used
Fig. 28
Line
Mic
Turn the knob PUSH /CONTROL to select the
setting; then press the button SETUP to save the
setting
4.6.2 Squelch
The interference suppression will mute the re-
ceiver section in speech pauses when interfering
signals are received and the levels of these sig-
nals are below an adjustable threshold value A
high threshold value, however, will reduce the
transmission range as the receiver will also be
muted when the power of the radio signal from
the transmitter falls below the threshold value
adjusted Therefore, adjust a high threshold value
when the reception is good and a low value when
there is a great distance between the transmitter
and the receiver
1) Call up the setting for interference suppression
via the menu item
Setup Squelch
Low
2) Turn the knob PUSH /CONTROL to change
the threshold value:
0 = standard setting
1 ... +10 the higher the threshold value, the
is shown
–1 ... –5 the lower the threshold value, the
3) Press the button SETUP to save the setting
4.6.3 Making settings for the transmitters
from the receiver
To make the following settings for the trans-
mitters on the receiver, go to the menu item
7.Mic Config
Menu item
1.Mic. Sensitivity
2.Mic. Attenuate
3.Mic. Low Cut
for connection to a line level input
for connection to a microphone input
4.Squelch
+4
0 High
Fig. 29
lower the sensitivity to interference
signals
higher the sensitivity to interference
signals
:
Setting
microphone sensitivity
without any function for
(TB) CS-W4T
high pass filter
: