Acova 40005959 Notice D'utilisation page 18

EN
SWITCHING THE MANUAL BOOST ON AND OFF
Press the BOOST key to start the blower for a set amount of time (see chapter
3.3, parameter 0 to modify it). The Boost indicator blinks throughout the manual boost
period for the blower.
Once the boost has started, you can adjust its operating time from between 15
to 120 minutes by pressing the + or - key repeatedly. You can stop it at any time simply
by pressing the BOOST key.
The symbol is displayed throughout the
duration of the manual boost. The time remai-
ning will scroll across the display until the end
of the preset period.
DAILY PROGRAMMES P1 AND P2
When activated, functions P1 and P2 allow you to run one or two automatic
programmes every day at the same time. The settings for P1 and P2 are independent.
These programmes activate a blower boost for a specific amount of time (30
minutes by default). The blower boost times can be modified (see chapter 3.3,
parameters 1 and 2).
IMPORTANT Starting a manual boost while P1 and/or P2 are activated will not
cancel the existing programming, which will take place as scheduled.
NOTE:
The total continuous blower operating time cannot exceed 2 hours (i.e. 120
minutes). An automatic 30-minute pause is programmed after 2 hours of
continuous operation. After this pause, the blower restarts. This automatic
stopping does not modify the programme end time.
32
3.1.3 Setting a daily programme
A
Press and hold P1 or P2 to access the start time set-
ting of the selected programme.
B
Symbols P1 or P2 and
time of programme P1 or P2 is displayed.
C
The start time of programme P1 or P2 can be adjusted
in 15-minute increments by pressing the + and - keys.
D
Press P1 or P2 briefly to quit setting mode, or do not
press any keys for 10 seconds to obtain the same result.
The start time is saved and P1 or P2 is activated.
Press P1 or P2 briefly to activate/deactivate programme P1 or P2. Symbol P1
or P2 is displayed on the screen to indicate it has been activated.
40005959 40005959
start to blink, and the start
P1 activated P1 non activated
EN
33