Using The Blower; Advanced Remote Control Settings - Acova 40005959 Notice D'utilisation

EN
A frame appears around symbol P1 or P2 when the programme start time is
reached and it continues to be displayed throughout the duration of the programme.
To suspend the programme while it is in progress, press P1 or P2 briefly.
The frame around symbol P1 or P2 will disappear. The programme will continue to be
repeated as usual over the following days.

3.2 Using the blower

Blower reset button
Filter LED
Alarm LED
Blower boost LED
For any problems or operational failures of the radiator and/or blower, please
refer to chapter 4.3.
The two most common problems encountered with the blower are summarised
below. The steps to take when one of these problems arises are described in the table
in chapter 4.3.
34
Reset
BOOST
FILTER
The alarm LED indicates a blower failure. Refer to chapter 4 to identify the
cause of this alarm.
The filter LED indicates when it is time to clean the filter (see chapter 4.2).
This LED also informs you of the absence or incorrect positioning of the filter on
the blower. If this is the case, the alarm and filter LEDs will blink simultaneously.
3.3 Advanced remote control settings (for advanced
users)
Some of the remote control parameters can be adjusted. The following informa-
tion will allow you to access these parameters and modify them according to your
intended use.
Access to the parameter settings is made with the remote control switched off.
If necessary, press and hold
Once the remote control has been switched off, press and hold keys P1 and
P2 together to access the settings menu. The following information will then be
displayed on the remote control screen:
Parameter number
Press P2 to access the next parameter. (0
Press P1 to access the previous parameter. (2
40005959 40005959
to switch it off.
Parameter value
1 2...)
1 0)
EN
35