Quick A 312 Manuel De L'utilisateur page 13

BEFORE USING THE WINDLASS READ THESE INSTRUCTIONS CAREFULLY.
IF IN DOUBT, CONTACT YOUR NEAREST "QUICK
WARNING: the Quick
poses. Quick ® shall not be held responsible for damage to equipment and/or personal injury, caused by a faulty
use of the equipment.
The windlass is not designed for the loads that might occur in extreme weather conditions (storms).
Always deactivate the windlass when not in use.
Check that there are no swimmers nearby before dropping anchor.
use a three-strand rope and form an effective splice, seeking expert advice if necessary.
recommend installing at least two anchor windlass controls in case one is accidentally damaged.
We recommend the use of the Quick
Secure the chain with a further device before starting the navigation.
The solenoid unit or reversing solenoid unit must be installed in a point protected from accidental water contact.
THE PACKAGE CONTAINS:
and screws (for assembly) - user's manual - warranty card.
TOOLS REQUIRED FOR INSTALLATION:
Ø 36 mm (1"7/16) hollow mill; hexagonal wrenches: 10 mm and 13 mm.
"QUICK ® "ACCESSORIES RECOMMENDED: anchoring RL control board (mod. 800) - Waterproof hand helds R/C (mod.
HRC1002) - Foot switch (mod. 900) - Hydraulic-magnetic circuit breaker - Anchor chain counter (mod. CHC1102M and CH-
C1202M) - Radio control (mod. 1302,1352; 02, 302).
INSTALLATION REQUIREMENTS:
the upper and lower surfaces of the deck are as parallel as possible. If this is not the case, compensate the difference appropri-
ately (a lack of parallelism could result in a loss of motor power). The deck thickness must be included among the figures listed
in the table. In cases of other thicknesses it is necessary to consult a Quick
the passage of cables, rope and chain; lack of depth of the peak could cause jamming.
FITTING PROCEDURE:
Remove excess material from the chain passage, refine and flatten with a specialized product (marine paint, gel coat or 2 pack
epoxy) to assure free passage for both rope and chain. Position the upper section, inserting the gasket between the deck and
the base and connect the lower section to the assembly, inserting the shaft into the reduction unit. Fix the windlass with the
screws provided onto the fixing studs. Connect the supply cables from the windlass to the reversing solenoid unit.
WARNING: before wiring up, be sure the electrical cables are not live.
AFR 300/500W - REV009C
®
windlasses are designed to weigh the anchor.
® hydraulic-magnetic switch as the motor safety switch.
windlass (on deck unit + motorgearbox) - reversing solenoid unit - base gasket - handle - bolts
drill and drill bits: Ø 9 mm (23/64") and Ø 11 mm (7/16") - Ø 55 mm (2" 1/8) and
the windlass must be positioned with the gypsy aligned with the bow roller. Ensure that
when the ideal position has been established, drill four holes using the drilling template provided.
INSTALLATION
® " DEALER.
Do not use the equipments for other pur-
For mixed rope-chain installation always
® retailer. There must be no obstacles under deck to
40 cm
(16")
max
5 mm
(3/16")
45°
90°
For improved safety we
90°
90°
GB
13