Assembly - Husqvarna K 4000 Manuel D'utilisation

Residual-current device
Ground fault circuit interrupters are for protection in case
an electrical fault should occur.
The LED indicates that the ground fault circuit interrupter
is on and that the machine can be switched on. If the
LED is not on, push the RESET button (green).
Safety instructions for maintenance
WARNING: The user must only carry out the
maintenance and service work described in
this Operator's Manual. More extensive work
Cutting blades
Husqvarna blades are high speed blades approved for
hand held power cutters.
• Cutting blades are available in two basic designs:
abrasive blades and diamond blades.
• High-quality blades are often most economical.
• Lower quality blades often have inferior cutting
capacity and a shorter service life, which results in a
higher cost in relation to the quantity of material that
is cut.
• Make sure that the right bushing is used for the
cutting blade to be fitted on the product. For
To fit the cutting blade on page 13 .
instructions, see
397 - 001 -

ASSEMBLY

Suitable cutting blades
Cutting blades
Abrasive blades
Diamond blades
Toothed blades
*Without water.
For more information, see
Cutting blades for different material
must be carried out by an authorized service
workshop.
WARNING: The engine should be switched
off, and the stop switch in STOP position.
WARNING: Wear personal protective
Personal protective
equipment. See
equipment on page 7 .
WARNING: The lifespan of the product can
be reduced and the risk of accidents can
increase if product maintenance is not
carried out correctly and if service and/or
repairs are not carried out professionally. If
you need further information please contact
your nearest service workshop.
CAUTION: Let your Husqvarna dealer
regularly check the product and make
essential adjustments and repairs.
K 4000
Yes*
Yes
No
Technical data on page 23 .
WARNING: Never use a cutting blade for
any other materials than what it was
intended to cut.
WARNING: Never use a diamond blade to
cut plastic material. The heat produced
during cutting may melt the plastic and it can
stick to the cutting blade and cause a
kickback.
WARNING: Cutting metal generates sparks
that may cause fire. Do not use the product
near ignitable substances or gases.
K 4000 with a
Vac attachment
No
Yes
No
9