Alutech Levigaro LG Série Manuel D'installation page 31

ADjUSTMENT
MENU SETTING
P7 f1
Y
f3
Y
f4
f5
P8 f1
f2
f3
f4
LEVIGATO DRIVES (LG SERIES)
DESCRIPTION
Select the operating mode of the photocells
(input 'PH1'). The input is activated when opening,
or is activated when closing
Connection input 'PH1' will be active only when closing (CL), if automatic closing is enabled
(pause time is set in P4-f1...f4 settings)
function 'PHOTOTEST' . The operation of the
photocells is checked before movement by
short-term disconnection and then reconnection
of the power to the photocells transmitter.
Photocells connection diagram—fig. 26
Function 'PHOTOTEST' cannot be switched off (no) if the automatic closing is enabled (pause
time is set in P4-f1...f4 settings)
Select the operating mode of the safety
sensor (input 'SE'). The input is not activated, or
is configured for a resistive sensor (8.2 kOhm),
or is configured for an optoelectronic sensor
(optosensor / OSE)
Photocells blocking close to the floor level
and the safety sensor (input 'SE'). The setting
specifies the distance from the floor where the
photocells and the safety sensors are ignored
The setting of output SL / LL in signal lamp
mode SL: continuous or flashing
The delay time of the movement beginning
(time of the preliminary activation of the signal
lamp). During the delay time, the signal lamp (SL)
works, it signals the beginning of door movement
by a set number of seconds
Operating time in the illumination lamp (LL)
mode and the drive illumination after stopping
the door movement
The output mode 'SL/LL': the signal lamp (SL) or
the illumination lamp (LL).
The signal lamp (SL)—works when the door
movement and when the door movement is
delayed (P8–f2 time setting).
The illumination lamp (LL)—works when the door
movement and after stopping the movement
(time setting P8–f3)
| LEVIGATO ANTRIEBE (SERIE LG)
CL—is activated
when closing /
OP—is activated
when opening
no—Off / on—ON
no—Off/
01—sensor
8.2 kOhm /
02—optosensors
no—Off /
01, 02, 03 ... 99
99—maximum
200 mm
no—flashing /
on—continuous
00, 01 ... 10
00—0
10—10
no / 01, 02 ... 99
no—after the end
of door movement it
is off (0 sec)
01—5
99—500
(8 min 20
no—signal
lamp / on—
illumination lamp
| COMMANDES LEVIGATO (SERIE LG)
DEfAULT
VALUES
VALUE
CL.
no.
no.
no.
on.
00.
,
sec
secs
06.
(30 secs)
;
secs
secs
)
secs
no.
29