Alutech Levigaro LG Série Manuel D'installation page 27

ADjUSTMENT
'rc' is shown on the display, which means that the recording of remote controls
6
is expected
Press the selected control button 3 times on the remote
7
(the first control button)
The number which is to be assigned to the remote in the drive memory, will
automatically appear on the display (with the button
8
number can be changed)
9 Press the button
In three seconds the automatic switch to the recording of the next remote con-
trol will take place. To exit the programming mode press the button
10
three times or wait for 15 seconds (until automatic exit the setup menu)
Deleting the remote control and defining of the record number of the remote
The table 12 describes the settings, it is used when there is a remote control but the information
for the remote control number in the drive memory is not available.
Press and hold the button
1
programming mode
2 After the appearance of 'P1' inscription press the button
3 After the appearance of 'P2' inscription press the button
With the button
4
'f7'—defining the number of the remote control;
'f8'—deleting the remote control
After the appearance of required setting ('f7' or 'f8') press the button
5
'rc' is shown on the display, which means that a signal from the remote control
6
is expected
Press the selected control button 3 times
7
The display will automatically show the number of the remote control in the
drive memory. If the remote control is not recorded, 'no' will be shown on the
8
display
To set 'f8' press the button
means that the remote control with the selected number is deleted from the
9
memory
LEVIGATO DRIVES (LG SERIES)
to confirm; after that a dot will appear on the display
or
| LEVIGATO ANTRIEBE (SERIE LG)
for about 5 secs to enter the
select the required setting:
. A dot will disappear from the display, this
| COMMANDES LEVIGATO (SERIE LG)
or the
Table 12
25