Alutech Levigaro LG Série Manuel D'installation page 26

ADjUSTMENT
SBS — the step-by-step control mode.
Sequence of commands OPEN—STOP—CLOSE—STOP—OPEN...
OP — the OPEN control mode. The command to open the doors
CL — the CLOSED control mode. The command to close the doors
STOP — STOP control mode. The command to stop the doors
PE — the pedestrian position control mode. The command for partial opening of door, if the partial
position of door is set (setting P1–f2)
LL — the light lamp mode. If the door does not move, the commands to turn on and off the built-in
lighting of the drive (illumination) and lamp connection output SL / LL are executed. The SL / LL
output is controlled with the remote if the light lamp LL output has been set up (P8–f4 setting)
Recording the remote controls
Y
ATTENTION! If you need to overwrite a previously recorded remote control (when you need
to record another button of the remote or record the remote in another mode), it must first be
deleted from memory!
The pressed button when recording will control the remote in the first mode in the list (tab. 10).
All other buttons of the remote control will be recorded automatically in the order specified in
the table 10 modes (refers to the settings in which several buttons are recorded).
MODE
1
2
3
4
In the case of f1-f4 settings, the unused buttons of the remote control can be recorded for
control in other ALUTECH products, where AT-4N remote control can be recorded.
Press and hold the button
1
programming mode
2 After the appearance of 'P1' inscription press the button
After the appearance of 'P2' inscription press the button
3
Using the button
4
control recording in the menu 'f1...f6'
After the appearance of required setting press the button
5
24
f1 f2
SBS SBS
— PE
— —
— —
or
LEVIGATO DRIVES (LG SERIES)
SETTING
f3 f4
SBS SBS
LL PE STOP
— LL
— —
for about 5 secs to enter the
select the required setting of remote
| LEVIGATO ANTRIEBE (SERIE LG)
Table 10
f5 f6
OP OP
STOP
CL CL
PE LL
| COMMANDES LEVIGATO (SERIE LG)
Table 11