Alutech Levigaro LG Série Manuel D'installation page 24

ADjUSTMENT
SETTING P1–f3: express-setup of the end positions and radio control setup
The end OPEN and CLOSED positions are set automatically with a switch to the recording of
remote controls in the programming mode P2–f1 (tab. 9).
Y
ATTENTION! Make sure that a support is installed on the rail for the OPEN position (fig. 16).
Simultaneously press and hold the button s
ATTENTION! Automatic movement of the door begins immediately. Watch
the movement of doors. The automatic setting can be stopped with pressing
1
any button on the drive panel.
Note: the express-setup procedure can be started similarly, if the mode 'P1' and
the setting 'f3' are selected
The door automatically moves to the contact point between the carriage rail
2
and the support, and a dot appears on the display
The door automatically moves to the CLOSED position. Movement continues
3
to the upper panel support, and after that a dot appears on the display
The door automatically moves to the OPEN position
4
The door automatically moves to the CLOSED position
5
'rc' is shown on the display, which means that the recording of remote controls
6
in 'step-by-step' mode is expected
Press the selected control button on the remote control three times
7
The indicator will automatically show the number offered for a remote control in
the drive memory (the number can be changed using the buttons
8
Press the button
9
In three seconds the automatic switch to the recording of the next remote control
will take place. To exit the programming mode press the button
10
times or wait for 15 seconds
SETTING P1–f2: setting the 'pedestrian position' / partial opening
The PEDESTRIAN position can only be set from the remote control board, recorded with this
control mode (menu P2 mode PE). The PEDESTRIAN position can be set from any position of
door (end or intermediate position).
22
)
to confirm; after that a dot will appear on the display
LEVIGATO DRIVES (LG SERIES)
and
| LEVIGATO ANTRIEBE (SERIE LG)
for 5 secs.
or
three
| COMMANDES LEVIGATO (SERIE LG)
Table 7