De Dietrich DRS 914 JE Guide D'installation Et D'utilisation page 35

This operation is made easer since there
is, in the internal part of the cover hinge lid
a groove that facilates the removal of this
coomponent.
"Remove the part marked with DX, if the
pivot pin is inserted in the right hinge, SX
in opposite case."
Apply covers (C-D) on joint cover lugs and
into hinge holes.Snap hinge covers (E)
into position.
5. Separate parts Ha, Hb, Hc, Hd as shown
in the figure.
6. Place guide (Ha) on the inside part of the
furniture door, up and down as shown in
the figure and mark the position of external
holes. After having drilled holes, fix the
guide with the screws supplied.
7. Fix cover (Hc) on guide (Ha) until it clips
into place.
8. Open the appliance door and the furniture
door at 90°. Insert the small square (Hb)
into guide (Ha). Put together the appliance
door and the furniture door and mark the
holes as indicated in the figure.
35