Proper Use; Ordering Spare Parts; Maintenance And Cleaning - EINHELL LE-R-OE 5 Mode D'emploi

Anleitung LE-R-OE 5 SPK 1
GB

5. Proper use

The appliance is designed only for private use, not
for commercial heating purposes.
6. Starting up
Important! Before using the appliance for the first
time, check that the voltage supply is the same as
the voltage details set out on the data plate.
6.1 Function switch (Fig. 5):
Low output – activate switch (1)
Medium output – activate switch (2)
Maximum output – activate switches (1+2)
6.2 Thermostat control (Fig. 5 / Item 3):
Switch on the required output using the two function
switches. Turn the control to "MAX" until the required
room temperature has been reached. Then turn
down the control until you hear a clear click. The
thermostat control will switch the radiator on and off
automatically to maintain the room temperature at an
almost constant level.
However, this presupposes that the radiator has a
sufficient output to cover the heating requirements
for the room.
7. Storage
If the radiator is not used for a lengthy period of time,
the mains lead must be stored in full in the
compartment provided for it. The radiator has to be
stored in a dry place, covered if possible.

8. Maintenance and cleaning

Maintenance and repair work may only be carried
out by an authorized electrical servicing contractor
or ISC GmbH.
Check the mains lead at regular intervals for signs
of defects or damage. A damaged mains lead may
only be replaced by an electrician or ISC GmbH in
compliance with the relevant regulations.
Important: Disconnect the mains lead before
cleaning – danger of electric shock.
Use a damp cloth to clean the casing.
The ribs are filled with a special oil. Repairs that
necessitate the oil seal to be opened may only be
6
23.04.2004 8:07 Uhr Seite 6
carried out by ISC GmbH. If oil leaks from the
appliance, return it to ISC GmbH for examination.

9. Ordering spare parts

Please provide the following information on all orders
for spare parts:
Model/type of machine
Article number of the machine
ID number of the machine
Number of the required spare part