Accessories; Warranty Conditions; Eu Declaration Of Conformity - Superrollo RM10MS Notice De Montage Et D'utilisation

Accessories

Installation plan for single-pin roller shutter switch
The following installation plan applies to the installation of the driving head on the
right-hand side.
Accessories
For tubular Article
motor
RM10MS Roller shutter drive accessory set for SW40,
consisting of:
■ 1 ball bearing
■ 1 counter bearing
■ 1 roller capsule
■ 3 securing springs
RM10MM Roller shutter drive accessory set for SW60,
consisting of:
RM20MM
■ 1 ball bearing
■ 1 counter bearing
RM30MM
■ 1 roller capsule
■ 4 securing springs
28

Warranty conditions

superrollo Hausautomatisierung GmbH provides a 5-year warranty for new
devices which have been installed according to these instructions. The warranty
covers all design faults, material faults and manufacturing faults.
The following are excluded from the warranty:
■ Incorrect installation
■ Non-observance of these instructions
■ Improper operation or strain
■ External effects such as shocks, impacts or weathering
■ Repairs and modifications by third-party, unauthorised bodies
■ Use of unsuitable accessories
■ Damage caused by impermissible overvoltage (e.g. lightning)
■ Malfunctions due to radio frequency overlay and other radio interference.
Defects which occur within the warranty period are rectified by superrollo free of
charge either by repairing or replacing the affected parts or by supplying an
equivalent or new replacement device. The delivery of a replacement or the
execution of repair due to warranty reasons does not equate to a general
extension of the original warranty period.

EU declaration of conformity

CE symbol and conformity
The superrollo RM10MS/RM10MM/RM20MM/RM30MM tubular motors meet the
requirements of Low-voltage Directive 2006/95/EEC, EMC Directive 2004/108
EEC and all applicable European and national guidelines. Conformity has been
Article No.
verified. The corresponding declarations and documents are stored by the
manufacturer.
SR50450
SR50560