Assembling The Device - Superrollo RM10MS Notice De Montage Et D'utilisation

Installing the device
In order to determine bearing position P in the roller shutter box, measure and
calculate the following dimensions:
D Diameter of the rolled up roller shutter
X D/2 Distance between the bearing position P and the
centre of the guide rail (3)
Y >X Distance between the bearing position P and the
bottom of the roller shutter box. So that the roller
shutter has sufficient clearance, Y must be greater
than X.
1
2
3
ATTENTION
Damage to the tubular motor due to the roller shutter being rolled
up slanted.
Make sure that the device is installed horizontally.
Using a pencil, mark the bearing positions P on the right and left inner sides of
the roller shutter box.
Make sure that the marks are aligned horizontally.
Hold the bearings centrally on the marks.
Mark the holes to be drilled using a pencil.
Drill the holes using an 8 mm drill bit.
Insert the plugs.
Screw the bearings down tightly.
Sawing the winding shaft to length
In order to determine the length L of the winding shaft, measure and calculate the
following dimensions:
A Clear width of the roller shutter box
B b1+b2+b3
b1 Depth of the counter bearing
b2 Width of the roller capsule limit stop
b3 1/3 of the roller capsule shaft length
C c1+c2+c3
c1 Depth of the adapter limit stop
c2 Depth of the driving head
c3 Depth of the drive bearing
L A-(B+C)
20
D
P
Y
X
B
b1 b2
b3
B
Using a pencil, mark the length L on the winding shaft.
Saw the winding shaft to length at a right angle using a metal cutting saw.
Deburr the inner and outer edges using a file.

Assembling the device

Slide the adapter (1) with the groove over the limit ring (2) spring on the driving
head (3).
1 2
1. Slide the driver (1) up to the limit stop onto the tubular motor's axle pin (2).
2. Secure the driver with the enclosed securing clip (3).
2
1
L
C
A
c1
3
3
1.
c2 c3
C
2.