Functions; Installing The Device - Superrollo RM10MS Notice De Montage Et D'utilisation

Functions

The device can be used to open and close roller shutters and awnings.
In order to carry out these functions, the tubular motor must be installed together
with the following superrollo accessories in the roller shutter box:
■ Winding shaft
■ Roller capsule
■ Ball bearing
■ Counter bearing
■ Securing springs.
Information on the superrollo accessories can be found in the chapter entitled
Accessories from page 28.
Permissible roller shutter areas and weights
The following table shows the roller shutter area permissible for the relevant motor
depending on the profile weight. The maximum roller shutter weight is additionally
listed.
Article No. Max. roller shutter area (m²)
4 kg/m²
(plastic)
RM10MS 4.2
RM10MM 4.2
RM20MM 8
RM30MM 12
Make sure that the maximum roller shutter area and the maximum roller shutter
weight are not exceeded.
Safety functions
The tubular motor is designed for short-term operation (four minutes). In order to
avoid damage to the motor, the motor shuts off automatically on exceeding this
period of time or in the event of frequent switching.
Safety shut-off may be attributable to various causes. Before the device is started
up again, you may have to rectify the cause. Information on possible causes and
their rectification can be found in the chapter entitled Rectifying malfunctions from
page 24.
Rectify the cause if necessary.
Allow the motor to cool for approx. 20 minutes.
If function remains impossible following these measures, contact the superrollo
customer service.
Max. roller
shutter weight
(kg)
7 kg/m²
(aluminium/wood)
2.8 22
2.8 22
5 44
8 66

Installing the device

Prior to installation
The following prerequisites must be met in order to be able to install the device:
■ The roller shutter box cover must be easily accessible and removable.
■ A 230 V~50 Hz current connection with an isolating facility (fuse) in the building
must be available at the installation location.
■ The weight of the roller shutter must be appropriate for the tubular motor.
Information on the permissible roller shutter weight can be found in the section
entitled Permissible roller shutter areas and weights from page 19.
■ The required superrollo accessories must be available. Information on the
superrollo accessories can be found in the chapter entitled Accessories from
page 28.
Check the scope of delivery for damage.
Do not operate the device if you discover damage on the device.
If damage is discovered on the device, contact the superrollo customer service.
Required tools
The following tools and fasteners are required to install the device:
■ Folding meter rule or measuring tape
■ Pencil
■ Spirit level
■ Metal cutting saw
■ File
■ Drill
■ 8 mm masonry drill bit
■ 8 mm plugs
■ Screws
■ Phillips screwdriver
■ Enclosed adjustment tool.
Installing the bearings
The motor's driving head can be installed on the right- or left-hand side of the
roller shutter box. Installation on the right-hand side is described in these
instructions.
The following points must be observed when installing the bearings:
■ The bearings must be aligned horizontally.
■ The roller shutter must be able to run vertically in the guide rail.
■ The roller shutter curtain must have sufficient space on all sides when rolled up
in the roller shutter box.
■ The tubular motor adjuster screws must be easily accessible following
installation.
■ In order to allow water to drip off, the motor cable must be routed downwards in
a loop directly before the motor.
Installing the device
19