Pendulum Action Settings; Using The Laser System - TOOLCRAFT 1582579 Notice D'emploi

• Plug the vacuum cleaner adaptor (14) onto the vacuum connection (10).
• Joint the vacuum cleaner adaptor (14) with the vacuum hose (15).
• Connect the vacuum hose (15) to an external dust extraction device.
Fig.B
f) Pendulum action settings
The saw blade pendulum action that is adjustable in four steps, makes possible the optimal adaptation
of sawing advancing (cutting speed), cutting performance and cut appearance of the machined
material.
For each downward movement, the saw blade is lifted off the material, which facilitates sawdust
ejection, reduces heat generated by friction and increases the service life of the saw blade. At the
same time, the reduction of the necessary advancing force provides fatigue-free working.
• The adjustment lever (7) makes possible the adjustment of the pendulum action in four steps. The adjustment
lever (7) can take place with the machine running:
Step 0:
No pendulum action;
Step I:
Small pendulum action;
Step II:
Medium pendulum action;
Step III:
Large pendulum action;
• The following basic recommendations are to be observed:
- The smaller the pendulum step selected (or switched off), the finer an cleaner the cut edge;
- When working with thin materials, like metal sheet, the pendulum action should be switched off (step 0);
- Material such as soft wood cut in the direction of the grain, the maximum pendulum action (step III) can be used.
g) Using the laser system
Always ensure the laser beam is aimed at a sturdy workpiece without reflective surfaces.
10 14 15
27