3
4
5
The network wizard and product setup can be performed independently. A network con-
nection is required for the Solar.web installation wizard.
Configure
1
Fronius Smart
Meter as primary
meter
2
3
4
5
6
7
8
9
The Fronius Smart Meter is configured as a primary meter.
Configure
1
Fronius Smart
Meter as a sec-
ondary meter
2
3
4
5
6
7
8
9
10
11
12
The Fronius Smart Meter is configured as a secondary meter.
28
Enter the IP address 169.254.0.180 in the address bar of the browser and confirm.
The installation wizard opens.
Follow the installation wizard and complete the installation in the individual areas.
Add the system components in Solar.web and commission the PV system.
Call up the website of the inverter.
-
Open web browser.
-
In the browser's address bar, enter the IP address (IP address for WLAN:
192.168.250.181, IP address for LAN: 169.254.0.180) or enter and confirm the
host and domain name of the inverter.
-
The website of the inverter is displayed.
Click on the "Device configuration" button.
Log in to the login area with user "Technician" and the technician password.
Call up the "Components" menu area.
Click on the "Add components" button.
Set the position of the meter (feed-in point or consumption point) in the "Position"
drop-down list. For more information on the position of the Fronius Smart Meter, see
Positioning
on page 7.
Set the converter ratio and the network type.
Click on the "Add" button.
Click the "Save" button to save the settings.
Call up the website of the inverter.
-
Open web browser.
-
In the browser's address bar, enter the IP address (IP address for WLAN:
192.168.250.181, IP address for LAN: 169.254.0.180) or enter and confirm the
host and domain name of the inverter.
-
The website of the inverter is displayed.
Click on the "Device configuration" button.
Log in to the login area with user "Technician" and the technician password.
Call up the "Components" menu area.
Click on the "Add components" button.
Select the meter type (generator meter/load meter) in the "Position" drop-down list.
Enter the previously assigned address in the "Modbus address" input field.
Enter the name of the meter in the "Name" input field.
Set the converter ratio and the network type.
Select the category (generator or load) in the "Category" drop-down list.
Click on the "Add" button.
Click the "Save" button to save the settings.