Fronius Gen24 Inverter; General; Installation With The Browser - Fronius Smart Meter 240V-3 UL Instructions De Service

Fronius GEN24 inverter

General

IMPORTANT! Settings in the "Device configuration" menu item may only be entered by
staff trained to do so!
The service password must be entered for the "Device configuration" menu item.
Three-phase or one-phase Fronius Smart Meters may be used. In both cases, selection
is made via the "Components" menu area. The meter type is determined automatically.
One primary meter and several secondary meters can be selected. The primary meter
must be configured before a secondary meter can be chosen.
Installation with WLAN:
the browser
1
2
3
4
5
6
The network wizard and product setup can be performed independently. A network con-
nection is required for the Solar.web installation wizard.
Ethernet:
1
2
Open the access point by touching the sensor once
flashes blue.
Establish the connection to the inverter in the network settings (the inverter is dis-
played with the name "FRONIUS_PILOT" and the serial number of the device).
Enter password: 12345678 and confirm.
IMPORTANT!
To enter the password in Windows 10, first select the "Connect using a security key
instead" link to be able to establish the connection with the password: 12345678.
Enter the IP address 192.168.250.181 in the address bar of the browser and con-
firm. The installation wizard opens.
Follow the installation wizard and complete the installation in the individual areas.
Add the system components in Solar.web and commission the PV system.
Establish a connection to the inverter (LAN1) using a network cable (min. CAT5
STP).
Open the access point by touching the sensor once
flashes blue.
→ Communications LED:
→ Communications LED:
27