Dirt Devil M0100 Manuel Du Propriétaire page 9

BELT OR BRUSHROLL REMOVAL & REPLACEMENT: CONTINUED
4. 5.
To remove the belt, hook the belt Remove screws on bottom of
on the left side of the motor shaft, metal nozzle guard as shown.
turn clockwise and pull the belt
towards you to release.
7. 8.
With the new belt properly located in Attach the metal nozzle guard,
the channel on the middle of the ensuring that tab is engaged
brushroll, slide the brushroll straight before securing with the
down into the unit. NOTE: Make sure screws.
the brushroll end caps align with the
tabs inside the brushroll housing (see
inset). Brushroll is not symmetrical, its
orientation is important.
10.
11.
Belt should look like the Attach belt door to unit and
illustration above. secure with screw.
IMPORTANT: THE BELT WILL
COME OFF IF NOT PROPERLY
INSTALLED.
6.
Remove metal nozzle guard and pull
brushroll and belt straight out from
unit.
9.
Dip the belt lifter inside the belt
access area and hook the belt
around the lip of the belt lifter.
Slip the belt onto the motor shaft
until the belt lifter base meets the
shaft. To ensure proper belt
placement, gently turn belt lifter
counterclockwise and remove.
Make sure belt is on shaft.
9