Changing The Wash Cycle - Bosch SHXM63WS5N Notice D'utilisation

en-us Operating the Dishwasher
Your dishwasher is protected
Note:
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
Cancel a cycle (Reset)
Open the door and press and
1.
hold Start button P for
approximately 3 seconds until the
display reads ‹:‹‚, then close
door again.
Wait about 1 minute while the
2.
dishwasher drains.
Open the door and press the
3.
On/Off button (.

Changing the wash cycle

When the Start button ( has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
38
Intensive drying
The final rinse uses a higher
temperature which improves the
drying result. The cycle time may
increase slightly. (Caution if utensils
are delicate!)
This feature has two settings:
š:‹‹ Off
š:‹‚ On
To change the setting:
Open the door.
1.
Press On/Off button (.
2.
Hold down function key # and
3.
press Start button P until the
display 8 shows •:‹x or š:‹x
(x can be any number).
Release both buttons.
4.
The indicator of function key #
flashes and the display 8
shows the factory set value.
Press function key # until the
5.
display 8 shows the factory set
value š:‹‹.
Press function key 3 to switch
6.
the feature on š:‹‚ or off š:‹‹.
Press Start button P to save
7.
setting.