en
Proceed as follows:
1. Before cleaning: Switch off the
appliance.
2. Pull out mains plug or switch off fuse.
3. Take out the frozen food and store
in a cool location. Place the ice pack
(if enclosed) on the food.
4. Wait until the layer of frost has thawed.
5. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light.
6. Wipe the door seal with clear water
only and then wipe dry thoroughly.
7. After cleaning reconnect and switch
the appliance back on.
8. Put the frozen food back into
the appliance.
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Take out glass shelves
Fig. )
Pull the glass shelf forwards, lower
and swing out to the side.
Taking out the freezer compartment flap
Fig. %
Open freezer compartment flap, hold one
of the bearing pins and remove flap.
Taking out the frozen food container
Fig. #
Pull out the frozen food container all
the way, lift at the front and remove.
Note
Before inserting the frozen food
container with telescopic rails, remove
the latter. Fig. $
34
Light (LED)
Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.
Tips for saving energy
Install the appliance in a dry, well
■
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Open the appliance as briefly as
■
possible.
To prevent increased power
■
consumption, occasionally clean
the ventilation opening with a paint
brush or vacuum cleaner.
Thaw frozen food in the refrigerator
■
compartment and use the low
temperature of the frozen food to cool
refrigerated food.
Leave warm food to cool down before
■
placing it in the appliance!
Ensure that the freezer compartment
■
door is always closed properly.
The arrangement of the fittings does
■
not affect the energy rating of the
appliance.