Assembling/Dismantling Parts - MAAX Z 01680 Mode D'emploi

EN

Assembling/Dismantling Parts

ATTENTION!
■ The cutting edges are sharp. Handle the product with care!
Collecting Container
1
Storage Compartment for the Inserts
Inserts
2
1
Lid and Pestle
To use the two lattice inserts, the lid (1) with pestle (14) is required. PLEASE NOTE: To
be able to attach or remove the lid, it must be at an angle of 90° to the frame.
2
1
• To remove the pestle, reach into the depression to the side of the pestle and pull it
away from the lid.
2. At the rounded end of the frame, there are two round recesses. Hold the lid at an
angle of 90° to the frame and slide the two lugs on the rounded end of the lid into the
two recesses in the frame.
• If you want to remove the lid again, tilt it so that it is at an angle of 90° to the frame
and then pull it out of the frame.
• First place the rounded tip of the collecting container (10)
into the rounded end of the frame (12) and then fold both
parts together until they engage.
• To remove the container again, carefully fold its wider end
away from the frame.
2
• The storage compartment for the inserts (11) is slid from
below into the guide rails of the frame. When inserting the
storage compartment into the rails on the upper edge,
press it in slightly.
• To remove the storage compartment again, simply slide it
out away from the frame below.
• The inserts are fi tted in the rectangular opening of the
frame. First plug the two locking lugs on the insert into the
associated openings in the frame and then fold down the
insert until it engages in place.
• To remove the insert, reach with your thumb into the de-
pression next to the insert and then fold it out and away
from the frame.
1. On the inside of the lid, there is a rectangular frame in
the middle for holding the pestle. First plug the two lock-
ing lugs of the pestle into the associated openings in this
frame and then fold down the pestle towards the lid until
it engages in place.
14