Manual Operation; Remote Operation - EQUATION EF431LV-E Notice De Montage, Utilisation Et Entretien

FR FR
5. INSTRUCTIONS FOR USE
ES ES
Temperature and serial number display: Normally it displays the room
temperature; while setting the temperature, the setting temperature is
PT PT
displayed; When setting the timer, serial number is displayed.
Time/ Temperature display: Normally it displays the current time; while setting
IT IT
the timer, the setting time is displayed. When setting the temperature of the
week timer, the setting temperature is displayed.
EL EL
Time on and time off: It is displayed while setting the timer, and it is used in
combination with serial number setting.
PL PL
Flame brightness: It displays the current brightness of the flame, which ranges
from one to five positions.
RU UA

6. MANUAL OPERATION

KZ
RO
EN
UA
This is done by operating the switches located at the top right hand side of the
fire .The standby rocker switch must first be switched on, the fire will beep to
RO
indicate that it is powered up.
Press the "F" button once to turn on the appliance and fire effect. A red
BR
indicator light will show to indicate that the fire is ON. Press the "F" button for
3 seconds, this will operate the dimmer mode, hold the button down until the
EN
desired brightness is obtained.
Press the 1000W button once for the low heat setting; press twice to switch off
the heat setting.
Press the 2000W button once for the high heat setting; press twice to switch off
the heat setting.

7. REMOTE OPERATION

The standby rocker switch located at the top right hand side of the fire must
first be switched on; the fire will beep to indicate that it is powered up.
It takes a little time for the receiver to respond to the transmitter. Do not
press the buttons more than once within two seconds for the fire to operate
normally.
114