Service; Safety Instructions Specifically For Impact Screwdrivers - Parkside PASSK 20-Li A1 Traduction Des Instructions D'origine

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
e) Do not use a battery pack or tool that is
damaged or modified. Damaged or modified
batteries may exhibit unpredictable behaviour
resulting in fire, explosion or risk of injury.
f) Do not expose a battery pack or tool to fire
or excessive temperature. Exposure to fire or
temperature above 130 °C (265°F) may
cause explosion.
g) Follow all charging instructions and do not
charge the battery pack or tool outside the
temperature range specified in the instruc-
tions. Charging improperly or at temperatures
outside the specified range may damage the
battery and increase the risk of fire.
CAUTION! RISK OF EXPLOSION!
Never charge non-rechargeable
batteries!
able battery from heat, for example from
continuous exposure to sunlight, fire, water
and moisture. There is a risk of explosion.
GB │ IE
20 
Protect the recharge-

6. Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
b) Never service damaged battery packs.
Service of battery packs should only be
performed by the manufacturer or authorized
service providers.
Safety instructions specifically for
impact screwdrivers
Wear hearing protection when impact
screwing. Exposure to loud noise can lead
to hearing loss.
Secure the workpiece! A workpiece securely
held by a clamping device or vice is much safer
than one held in your hand.
Hold the power tool firmly. High torques can
occur for brief periods while tightening and
loosening screws.
Wait until the power tool has come to a stand-
still before putting it down. The tool can jam,
this leading to loss of control of the power tool.
Hold the power tool by the insulated gripping
surfaces, when performing an operation where
the screw could come into contact with hidden
wiring. Contact between the screw or attached
tool and a live wire may cause exposed metal
parts of the power tool to become live and give
the operator an electric shock.
PASSK 20-Li A1

Publicité

Table des Matières
loading

Table des Matières