Faults - WIKA TR12-A Mode D'emploi

5. Commissioning, operation / 6. Faults
Only ever screw in, or unscrew, the instrument via the spanner flats and to the
■
prescribed torque using an appropriate tool.
The correct torque depends on the dimensions of the connection thread and the sealing
■
used (form/material).
When screwing in or unscrewing the instrument, do not use the connection head as
■
contact surface.
When screwing in the instrument, please observe that the threads are not skewed.
■

6. Faults

CAUTION!
Physical injuries and damage to property and the environment
If faults cannot be eliminated by means of the listed measures, the instrument
must be taken out of operation immediately.
▶ Ensure that there is no longer any signal present and protect against being
put into operation accidentally.
▶
Contact the manufacturer.
▶
If a return is needed, please follow the instructions given in chapter 8.2
"Return".
WARNING!
Physical injuries and damage to property and the environment caused
by hazardous media
Upon contact with hazardous media (e.g. oxygen, acetylene, flammable
or toxic substances), harmful media (e.g. corrosive, toxic, carcinogenic,
radioactive), and also with refrigeration plants and compressors, there is a
danger of physical injuries and damage to property and the environment.
Should a failure occur, aggressive media with extremely high temperature
and under high pressure or vacuum may be present at the instrument.
▶
For these media, in addition to all standard regulations, the appropriate
existing codes or regulations must also be followed.
▶
Wear the required protective equipment (depending on the application; the
thermometer itself is basically not dangerous).
For contact details see chapter 1 "General information" or the back page of
the operating instructions.
WIKA operating instructions models TR12, TC12
EN
17