Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
18.2 Retracting the machine .................................................................................... 47
18.2.1
Performing a test run ................................................................................47
18.3 Operating the machine ..................................................................................... 47
18.3.1
Control icons ...........................................................................................47
18.3.2
Operating instructions ...............................................................................48
18.3.3
Switching on the machine .........................................................................48
18.4 Setting spindle speed and rotation direction .................................................... 48
18.4.1
Spindle speed selection .............................................................................48
18.4.2
Direction of rotation .................................................................................49
18.4.3
Running operation ....................................................................................49
18.5 Threads and feeds ............................................................................................ 49
18.5.1
Change gear gearbox ...............................................................................49
18.5.2
Manual feed.............................................................................................49
18.5.3
Automatic feeds and threas pitches ............................................................50
18.5.4
Thread dial indicator (for resuming the pitch) ..............................................50
18.6 Tool post ........................................................................................................... 51
18.7 Mounting steady or follow rests ....................................................................... 52
18.8 Tailstock ........................................................................................................... 52
18.8.1
Tailstock laterally offset ............................................................................52
18.9 General working instructions ............................................................................ 53
18.9.1
3-jaw chuck.............................................................................................53
18.9.2
Longitudinal turning .................................................................................54
18.9.3
Plain turning and recessing ........................................................................54
18.9.4
Fixing the lathe slide ................................................................................54
18.9.5
Turning between tips ................................................................................54
18.9.6
Turning short taper with the top slide .........................................................54
18.9.7
Thread cutting .........................................................................................55
20.1 Inspection and maintenance plan ..................................................................... 56
20.1.1
Adjusting the taper gibs ............................................................................56
20.1.2
Other lubrication points .............................................................................57
20.1.3
Replacing / tightening the V-belt ................................................................57
20.1.4
Replacing jaws .........................................................................................57
20.1.5
Check / change carbon brushes .................................................................58
25.1 Uso conforme a las especificaciones ................................................................. 61
25.1.1
Limitaciones técnicas ................................................................................61
25.1.2
Aplicaciones prohibidas / aplicaciones indebidas peligrosas ............................61
25.2 Requisitos del usuario ...................................................................................... 61
25.3 Dispositivos de seguridad ................................................................................. 62
25.4 Indicaciones generales de seguridad ................................................................ 62
25.5 Seguridad eléctrica ........................................................................................... 63
25.6 Indicaciones especiales de seguridad para tornos ............................................ 63
25.7 Advertencias de peligro .................................................................................... 63
27.1 Tareas preparatorias ........................................................................................ 65
27.1.1
Comprobación del volumen de suministro ...................................................65
27.1.2
Limpieza y lubricación ...............................................................................65
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
INHALT /INDEX
55
56
58
58
58
60
61
64
65
4
ED300ECO
Publicité
Table des Matières
