Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SeCURe MOUNTING ASSeMBly
• Slide carrier to expose
unsecured bail screw.
• Use hex wrench
to tighten both bail
screws.
TIGhTeN CARRIeRS TO
MOUNTING BRACKeTS
For added security, ensure
bail screw heads are
covered with the slider top.
veRIFy BINdING
CleARANCe
If you have sufficient clearance,
PROCEED TO sTEP
If you need more binding clearance, or
if factory bars are arched and cannot
align with carriers,
CONTINUE TO NEXT sTEP
ReMOve BASe SCReW AT hINGed
SIde OF CARRIeRS
Remove screw closest to hinge.
1033383C - /15
Make sure
In some cases, the
carriers are
mount will sit at an
vertically aligned
angle.
and both mounts
are at the same
angle.
lOAd SKIS OR SNOWBOARdS
• Lower your bindings first!
• Keep the tips toward the rear of the vehicle.
SKIlIFT AdjUSTMeNT:
OPeN CARRIeRS
lIFT hINGed SIde
OF CARRIeR
Reinstall base
screw into
mounting
bracket.
OPeN CARRIeR
lOOSeN FRONT
BASe SCReW
DO NOT remove the screw!
Publicité
Table des Matières
