Drive Aston Manuel D'utilisation page 5

Foreword
We congratulate on the buying of a technically matured
and the best available technology product.
This instructions helps you and the carers as a basis for
sure, safe use of the toilet wheel chair and a sensitive
use of the product's possibilities.
The instructions describes the preparation, service, use,
servicing and cleaning of the product.
This instructions is to be perused carefully and must be
always accessible to all users of the product.
Indication
Shower-Toilet wheelchairs are necessary when using
or achievement of the toilet is not possible because of
a handicap. Shower-Toilet wheelchairs are also usable
as room wheelchairs. Shower-Toilet wheelchairs can be
pushed over customary toilet bowls.
Contraindication
The wheeled commode is not suitable for persons
• with reduced or impaired ability to sit
• with significantly impaired cognitive ability
Safety instructions
• Read this instructions carefully.
• Before use all components are to be checked for
damages and firm seat.
• While seating, rising and while inserting the toilet
bucket as well as folding up or engaging the armrests
it`s possible to pinch clothing or body Parts.
• Always apply the parking brake when using the shower-
toilet wheelchair.
• Before getting in/out from the shower-toilet wheelchair
swing away the footrests.
• Never use the footrests as stand up device - Tilting
danger!
• Protect from unauthorized use, e.g., by children, by
locking the brakes
Reapplication
This product is suitable for reapplication.
With the processing the standards of the manufacturer
must be considered. This standards are made available
on inquiry.
Assembly
Insert the four 5" wheels in the admission pipe in the
frame in the desired position and fix them with the pro-
vided bolt clips. (See picture 1+2).
1
Put the premounted backrest on the basic rack and fix
it with the star screws with a clockwise rotation. (See
picture 3).
3
Locate the seat by sliding the back of the seat in to the
frame. Then press down on the whole of the seat until
secure. Add the aperture cover if required.
Insert the bucket from the rear side into the guiding
under the seat plate, after use pull out also from the
rear side. (Picture 4).
Attach the footrest by placing the top bracket in to the
receiver tube at the top of the frame, ensuring the footrest
is swung back. (Picture 5).
Swing the footrest towards the front of the chair until it
locks in position. (Picture 6).
Repeat for the other footrest and adjust the footplate
height and angle if required. (see instructions).
5
2
4
6
EN
5