Rollei ePano II 360 DSLR Guide De L'utilisateur page 11

Settings
1. Turn the power switch on. If the R.T LED „5'" and the Duration LED
„15°" are constantly shining, the device is working correctly.
2. By pushing the duration button the different angles can be changed.
Choose an angle (e.g. 90°) by pushing the duration button until the
light of this angle turns on. Then this angle is selected.
3. By pushing the R.T button the different time modes can be changed
to accomplish the angle that is selected. Push the R.T button until the
light of the time you want is on (e. g. 5'). Then the time is installed.
4. Push the start/stop button to start or stop the Rollei ePano II 360
DSLR with the selected settings. If the device is totally turned off then
the settings will not be saved.
5. The Rollei ePano II 360 DSLR can be run clockwise or anti-clockwise.
Therefore press the duration and R.T button shortly. Please note that
the Rollei ePano II 360 DSLR needs to be turned on but should not be
working if you do this setting.
6. After the usage of the Rollei ePano II 360 DSLR please turn it off.
Then all lights on the device will be turned off.
11