HQ Power VDP250MH6/2 Notice D'emploi page 5

• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
5. Use
a. The moving head is controlled by 6 DMX channels:
CHANNEL 1 : pan movement (max. 540°)
CHANNEL 2 : tilt movement (max. 270°)
CHANNEL 3 : colour wheel
CHANNEL 4 : gobo wheel
CHANNEL 5 : program, shaking gobo
CHANNEL 6 : scan speed
HINT: to make a strobe effect: select the open gobo on channel 4 and use program 1 on channel 5.
b. Detailed DMX values per channel:
CHANNEL 1
CHANNEL 2
CHANNEL 3
CHANNEL 4
CHANNEL 5
CHANNEL 6
c. DMX-512 Connections
Connect the provided XLR cable to the female 3-pin XLR output of
your controller and the other side to the male 3-pin XLR input of the
VDP250MH6/2. Multiple VDP250MH6/2s can be linked through
serial linking. The linking cable should be two core, screened cable
with XLR input and output connectors.
Please refer to the diagram at the right.
VDP250MH6/2_v2
Description
Pan
Tilt
Colour wheel
Gobo wheel
Program
Shaking gobo
Scan Speed
From To Function
0 255 8 bit
0 255 8 bit
0 24 Open / white
25 49 Red
50 74 Yellow
75 99 Blue
100 124 Green
125 149 Mauve
150 174 Orange
175 199 Pink
200 255 Rainbow effect
0 16 Closed
17 33 Open
34 50 Star
51 67 Gobo 1
68 84 Gobo 2
85 101 Triangle
102 118 Spots
119 135 Dotted line
136 152 Square
153 169 Spiral
170 186 Four Dots
187 199 Star sky
200 255 Gobo cycle
0 15 Shutter open
16 91 Program 1: gobo change
92 135 Program 2: colour change strobe
136 195 Program 3: gobo and colour change
196 255 Gobo shake (slow→fast)
0 255 Set pan/tilt scanning speed (fast→slow)
5
HQPOWER