Lindy 38209 Manuel Utilisateur page 7

User Manual
provided. The extension cables allow an IR remote control to be used from the Transmitter to the
Receiver or vice versa.
Digital Audio
The Transmitter and Receiver units both feature an Optical SPDIF In and Out port, allowing separate
digital audio signals to be extended from the Transmitter to the Receiver, from the Receiver to the
Transmitter or in both directions simultaneously.
Analogue Audio
The Transmitter features an analogue stereo input via a 3.5mm stereo audio socket with the
corresponding output on the Receiver, allowing an additional audio source to be extended alongside a
HDMI signal.
Troubleshooting
There is no display on the screen.

As of May 2015 it has been found that there are significant differences in the cable lengths/types and
even input ports which can be used on different brands of HDTV using HDMI 2.0 4K 60Hz. If you
experience problems, please use the following steps:

Try a different input port on your HDTV.

Reduce the cable length on the Input and Output to 1m.

Try a different type of 1m HDMI Cable.

Check that the DC plug and jack used by external power supply are firmly connected and that the
power LED is illuminated on both the Transmitter and Receiver.

Check that the Cat.5e/6/7 cable is plugged in correctly and that the Yellow Link Status LED on both
the CAT5e/6/7 In and Out ports are lit.

Power off all the devices, then power on in this order: first, the transmitter unit, then the display and
finally the source.

For several HDMI devices it may be helpful to unplug and replug their HDMI connection to re-initiate
the HDMI handshake and recognition.

Reduce the length of Cat.5e/6/7 or HDMI cable used, or use a higher quality cable.
USB Devices are not working.
 Ensure that the device and host connections are made securely
 Check that the USB-D/USB-H Select Switch (8) is set to Host on one unit and Device on the other
according to your requirement
Make sure that no USB device or cable is attached to the any USB port on the Extender which is not

set to active. (e.g. no cable connected to the USB-H port when the USB-D/USB-H Select Switch (8)
is set to Device).
 If the above steps have been made please power cycle the Extender
English