Sangean RCR-7WF Mode D'emploi page 32

DST(Auto time set by Internet)
This is the function that real time set by Internet
These are options available:
Auto(US) – Sets your radio to the US time
Auto(EU) – Sets your radio to the EU time
None – Disable the auto time set
Manual – manually set up
1. Press the Power button to switch on your radio.
2. Press the tuning+/- button until the display shows <Setting>.
Press the Select button to enter the configure settings.
3. Press the tuning+/- button until the display shows <Clock Setup>.
Press the Select button to enter the clock setup menu.
4. Press the tuning+/- button until the display shows <DST>. Press the
Select button to enter it, then you will be able to set the DST.
* Go to the direction of Setting > Clock Setup > Local Time Zone,
to forward or backward 30 mins/step to set up your time difference
from the DST provided by Internet.
31
Setting the alarm clock
Your radio has 2 separate alarms which can be set to wake you to either
FM radio, buzzer, Aux In, or Internet Radio. Each alarm can be set to
sound either once, everyday, weekly, weekdays or at weekends. In the
event of a power interruption your radio has built in memory chip that
will retain your alarm settings.
Note: If no buttons are pressed for 10 seconds the radio will exit the
alarm setup. If you make a mistake at any point, press the Back button
to go back to the previous screen.
1. Long Press Alarm1 (or Alarm2) button until it shows "Enable Alarm",
YES/NO selection.
2. Press the Tuning+/- buttons and the Select buttons to select "YES".
And the display will show " Set Alarm".
3. Press the Tuning+/- buttons to set the hour, then press the
Set button.
4. Press the Tuning+/- buttons to set the minute, then press the
Set button.