Télécharger Imprimer la page

Maco PROTECT Notice D'utilisation page 10

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
3. Identification
Requirements: The device must be switched to operating mode (only
the blue LED is lit)
Swipe a user-finger over the sensor
Once a finger is identified the green LED turns on and the relay is
active.
If the finger is not correctly identified the red LED turns on.
4. Locked mode (Terminal Lock and Unlock)
Lock: Swiping over the sensor with an un-enrolled user-finger for
five times (red LED on), the device will switch to locked mode and
will prevent any unauthorized person from access.
Unlock: You can deactivate the locked mode by swiping an
enrolled finger (master-finger or user-finger) twice, consecutively,
over the sensor.
The red blinking LED indicates that the device is in locked mode.
The locked mode will initially have a limited duration. After five
more incorrect entries the locked down time will be extended
(blocking intervals: 1 minute, 5 minutes, 30 minutes, 1 hour,
permanent block).
5. Delete all fingers (including master-fingers, Reset):
Current Code
Please hold the IR (Infrared) remote control in front of the IR inter-
face (blue LED): Press DA ->Cancellation CODE -> OK
The device is now reset to initial default settings
(red + green+ blue LEDs are on steadily)
Cancellation code (4-6- digit code):
To change the code (very important): press D-> E-> factory
code -> OK-> NEW Cancellation Code -> OK
Note: An additional option to delete all fingerprints is available
directly on the external unit (fingerprint reader).
Please swipe the master-finger three times consecutively over
the sensor. After the first swipe of the master finger, the green
and red LEDs light up constantly. Once they go out again, please
swipe the master finger a second time. Now the green and red
LEDs flash. Once these two LEDs start flashing flash, swipe the
master finger once more in order to begin the removal process.
This will be indicated by the green LED.
The device is now reset to the initial default settings (red +
green+ blue LEDs are on steadily).
- 10 -

Publicité

loading