Yard force NX 60i Guide D'installation D'origine page 13

GB
Charging trouble shooting
Problem Possible cause
Incorrect wire connection
No light on charge base
AC Power has not been switched
ON
S1 or S2 indicator flashes
Boundary wire broken, no signal
separately
Machine not correctly docked in
charge base
Robot not charging
Charger pins corroded
Mowing trouble shooting
Problem Possible cause
ON/OFF key has not been
activated
No Power to machine
Robotic Mower has low charge
Time setting not activated
Grass build up under deck
Battery power low
Machine fails to START Grass too long
Cutting height is too low
Battery temperature too cold /hot
Boundary wire broken
Mower outside the
Boundary wire is on a slope
boundary wire
Mower needs more cutting time
Parts of the lawn are
uncut
Grass too long
Obstacles on lawn
Mower gets stuck in Lawn Boundary wire not correct laid
area
Wire in front of docking station
incorrect installed
Blade loose
Blades damaged jammed
Excessive vibration/noisy
Grass maybe to high
Cutting motor failure
Corrective action
Check wire connections "F and B"
Switch on AC power
Repair broken cable with provided
connectors
Check machine is fully docked in
charge base
Check charge base is on flat
surface
Clean the charger pins
Corrective action
Switch ON the machine and try
again
Place machine in the docking
station
Select time schedule and then try
again
Clean under deck with brush
Place machine in docking station
Mow the lawn to 60mm
Mow the lawn to 60mm and raise
cutting height
Working condition is between 5
o
and 45 C
Repair broken boundary wire
Modify boundary wire and leave
bigger distance on slope
Increase scheduled cutting time
Mow the lawn to 60 mm
Remove obstacles from the lawn
Modify boundary wire to zone out
obstacles
1.5 m of straight cable to front of
docking station needed
Tighten screw bolt
Replace damaged blades
Increase cutting height, reduce
later step by step or mow the lawn
with ordinary lawnmower first
Please call the after sales service
20
Problem Possible cause
Power cable runs parallel/close to
wire
Front wheel is stuck
Signal interfere with robot in
Mower runs in circles neighborhood
Driving motor failure
Connection issue or broken/cut
boundary wire
Corrective action
Reposition of boundary wire
Clean front wheel area
Change to alternative boundary
signal (S1/S2)
Please call after sales service
Repair/check connections on
charge base and boundary wire
being broken/cut
21
GB