Controls At A Glance - Maytag Neptune MD55 Guide D'utilisation

A
C C
ONTROLS T A
Step 1
Sensor Dry – automatically senses the moisture in the load
and shuts the dryer off when the selected dryness level (very
dry to damp dry) is reached.This cycle is recommended for the
majority of loads including delicates, wrinkle free and
cotton/sturdy items like towels, bedding and jeans.
Or
Time Dry – may be selected for any load if sensor dry is not
used. Press the "+" or "–" time pad to select the desired number
of minutes.
Step 2
Dry Temp – there are four temperature settings. Press the
up " " or down " " pads to select regular, medium, delicate
or extra low temperatures.
Regular – for sturdy cottons or those labeled "Tumble
Dry."
Medium – for permanent press, synthetics, lightweight cot-
tons or items labeled "Tumble Dry Medium."
Delicate – for heat sensitive items labeled "Tumble Dry
Low" or "Tumble Dry Warm."
Extra Low – provides the lowest heated dry temperature
possible. Extra low temperature is lower than delicate.
Step 3
Select Dryness Level – press the " " or " " arrow pads
to select the desired dryness level.The dryness level can be set
on or between a setting.
Very Dry – used to completely dry sturdy or bulky items
including towels and jeans.
Normal – used for drying the majority of loads.
Damp Dry – designed to partially dry items. Used for items
that lay flat or hang to dry.
Step 4
Setting the Signal – the end of cycle signal is adjustable.
Press the "+" or "–" signal pad to increase or decrease the
volume of the signal.
G
LANCE
5