brennenstuhl professional LINE LA 4010 Mode D'emploi page 9

INSTRUCTIONS FOR CHARGING THE BATTERY
Only use one of the chargers listed in the following.
Only these chargers are calibrated to the Li-Ion batteries used in your battery-operated light.
brennenstuhl professionalLINE CB 1801 charger
®
BOSCH AL 1820 CV Professional charger
BOSCH AL 1860 CV Professional charger
Note: The battery is delivered with a partial charge. To ensure the full capacity of the battery, fully charge the
battery in the charger prior to the first use. The Li-Ion battery can be charged at any time without reducing
its service life. Interrupting the charging process does not harm the battery. The Li-Ion battery is protected
against deep discharges by the "electronic cell protection (ECP)". If the battery is discharged, the battery-
operated light will be shut off by a circuit breaker.
PIVOTING THE LIGHT HEAD
The light head can be pivoted as needed. To set the tilt angle,
G
loosen the locking screw (turn counterclockwise),
H
set the desired tilt angle and tighten the locking screw again
(turn clockwise).
CABLE HOLDER / SUSPENSION DEVICE
The light is equipped with a cable holder which can house
I
the power cable during transport or when used with a battery.
Unfolding the cable holder:
The cable holder is folded back when the unit is delivered.
To use the cable holder, pull the two brackets slightly upward and
then turn them outward until they reach the position shown in
the illustration. Now the cable can be coiled on the two holders.
If the cable holder is unwound, the cable holder can also be used
to hang the light, e.g. on a railing, etc.
MAINTENANCE AND CLEANING
If the battery is no longer functional, it must be replaced.
The battery-operated light does not require maintenance.
The LED light source cannot be replaced. If necessary, replace the entire spotlight. Never open the light
when the mains supply cable is connected. Risk of life due to electric shock!
Switch the light off and disconnect the power plug before cleaning. Clean the light regularly with a dry, lint-free
cloth. To remove dirt, a damp cloth can be used. Do not use any solvents, caustic cleaning agents, etc.
www.professionalline.com 9
010916 BA_proLINE Hybrid_SMD-LED Strahler 40W (Aurolite).indd 9 20.06.17 13:02