Initial Operation; Function Switch; Overheating Protection - Clatronic HL 2771 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

5....-05-HL 2771

1. Only connect the machine to a properly installed safety socket, 230 V/50 Hz.

2. Make sure that the degree of protection of the socket to which the device is

connected is of at least 10 ampere!

3. Place the device on any heat-resistant flat surface. Ensure that air can enter

and leave unhindered. The distance from the air inlet and outlet grill to the

nearest wall should be at least 20 centimetres.

4. The indicator light lights up when the unit is in operation.

5. After use, pull the plug out of the socket.

= OFF

= Hot air (1000 W)

•

You can set the room temperature with the temperature control.

–

= Lowest level

•

Turn the thermostat control knob to the highest level. The LED will light up.

•

Once the desired room temperature is reached, turn the thermostat control

knob slowly back until the device shuts off. The thermostat maintains the set

room temperature by switching the device on and off.

Cold air operation:

If you would like to use the machine as a ventilator, move the function switch to

and turn the temperature regulator to the + position.

The device is equipped with an overheating protection that switches the device

automatically off in case of overheating. Shift the function switch to „0" position and

pull out plug out of the socket. Let the device cool down for about 10 minutes before

using it again.

Should the overheating protection shut the device off again shortly after, there is

probably a defect. Switch off the device again and pull out the plug. Let the device

be checked by an authorized dealer or by our customer service (or contact your

dealer).

05.05.2003 9:47 Uhr