Create Or Edit A Pump Program - MANOSTAT Compulab 3 Notice D'utilisation

CREATE OR EDIT A PUMP PROGRAM

To create a new pump program, ensure that the console displays the PROGRAM MENU. If any other menu appears,
press the BACK key until the PROGRAM MENU is displayed.
Press the arrow under NEW to create a new program or press the arrow under EDIT to select a program to revise.
Follow the flowchart in Figure 10 to create or edit a pump program.
REQUIRED PARAMETERS
ENTER PUMP TYPE,
TUBE SIZE, AND RATE
OPTIONAL PARAMETERS
ENTER ACCEL, DECEL
NO-DRIP , AND DIRECTION
INPUT A PROGRAM NUMBER
(1 – 30)
AND PRESS
PRESSING
A NUMBER RUNS THE PROGRAM.
( REFER TO RUNNING A PUMP PROGRAM
PROGRAM MENU LINKED:NONE
NEW EDIT:##
PUMP MENU PUMP MENU
DRIVE:RD2 DRIVE:RD2
PUMP OPTIONS MENU PUMP OPTIONS MENU
ACCEL:0.0s DECEL:0.0s NO-DRIP: 0 ACCEL:0.0s DECEL:0.0s NO-DRIP: 0
SAVE PROGRAM SAVE PROGRAM
PROGRAM NUMBER:0 PROGRAM NUMBER:0
ENTER TO SAVE
ENTER WITHOUT ENTERING
)
Figure 10. Pump Menus
LOAD LINK
ENTER CONTINUES #1 ENTER CONTINUES #1
TUBE:0 TUBE:0 RATE: RATE: 0.0mL/MIN 0.0mL/MIN
ENTER CONTINUES #1 ENTER CONTINUES #1
ENTER CONTINUES #1 ENTER CONTINUES #1
0 = NOT SAVED 0 = NOT SAVED
10
PUMP
#1
PUMP
OPT OPT
PUMP
DIR:CW DIR:CW
PUMP