Remington LUXE COMPACT Mode D'emploi page 5

ENGLISH
Ensure the inlet grille is free from obstructions such as household fluff, loose hair etc.
Do not place hairdryer on soft material e.g. carpet, bedding, towels, rugs etc.
Do not leave the dryer switched on when you set it down.
Always ensure the voltage to be used corresponds to the voltage stated on the unit.
Do not direct the airflow towards the eyes or other sensitive areas.
Keep this product out of reach of children. The use of this appliance by persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge can
give cause to hazards. Persons responsible for their safety should give explicit instructions
or supervise the use of the appliance.
Do not use any attachments with this hairdryer, other than those supplied by Remington
Avoid allowing any part of the hairdryer to contact the face, neck or scalp.
This appliance is not intended for commercial or salon use.
If the supply cord of this unit becomes damaged, discontinue use immediately and
return the appliance to your nearest authorised Remington
replacement in order to avoid a hazard.
Special tools are required for any examination, adjustment or repair. Unqualified repair
work could lead to hazardous conditions for the user.
We do not accept responsibility for damage to the product, persons or other item(s),
caused by misuse, abuse or non-compliance with these instructions.
This product is fitted with a BS1363 plug fused at 13A. If the plug is unsuitable, it should be
disconnected and an appropriate plug fitted as detailed below. If it is necessary to replace
the plug fuse, use only fuses that are approved to BS1362, rated at 13A. If in doubt consult a
qualified electrician.
The wires in the mains lead are coloured in accordance with following code:
As the colours of the wires in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
- The wire which is coloured BLUE must be connected to the terminal which is marked 'N' or
coloured BLACK. The wire which is coloured BROWN must be connected to the terminal
which is marked 'L' or coloured RED. Never connect either of the wires to the big EARTH
terminal marked 'E' or coloured GREEN or GREEN AND YELLOW.
100348_REM_IFU_D2011_21L.indd GB_3 100348_REM_IFU_D2011_21L.indd GB_3
WIRING INSTRUCTIONS UK PLUGS ONLY
BLUE - NEUTRAL
BROWN - LIVE
®
service dealer for repair or
® .
3
09.05.10 22:01 09.05.10 22:01