Using The Controls - Amana AFI2538AEW Guide D'utilisation

Using the Controls

Initial Temperature Setting
Temperatures are preset at the factory at 38° F (3° C)
in the fresh food compartment and 0° F (-18° C) in the
freezer compartment.
Adjusting the Control
24 hours after adding food, you may decide that one or
both compartments should be colder or warmer. If so,
adjust the control as indicated in the Temperature
Control Guide below.
• Do not change either control more than one degree
at a time. Allow temperature to stabilize for 24 hours
before making a new temperature adjustment.
Temperature Control Guide
Refrigerator too cold
Refrigerator too warm
Freezer too cold
Freezer too warm
Turn refrigerator off
Set the Refrigerator control
to next higher number by
pressing the pad.
Set the Refrigerator control
to next lower number by
pressing the pad.
Set the Freezer control to
next higher number by
pressing the pad.
Set the Freezer control to
next lower number by
pressing the pad.
Press the Freezer pad
until "OFF" appears in the
display. Press the in
either the freezer or
refrigerator section to turn
back on.
Front Fill Button (select models)
The Front Fill Button works independently of
the dispenser controls, providing an up-front
alternative to the dispenser pad for
dispensing water. This feature is convenient for filling
large items that will not fit into the dispenser area (i.e.
sport bottles, pitchers, large pans, coffee pots). This
feature allows added convenience of dispensing ice
and water simultaneously. To use, choose Cube mode
from dispenser control panel. Press container against
dispenser pad while pressing the Front Fill button.
Water Filter Status Indicator Light
When a water filter has been installed in the
refrigerator, the yellow Order light will
illuminate when 90 percent used OR 11
months have elapsed since the filter has been
installed.
The red Replace light will illuminate when the rated
volume of water has passed through the filter OR 12
months have elapsed since the filter was installed. A
new filter should be installed immediately when the
Replace light is illuminated.
After replacing the filter, press and hold the Reset Filter
pad for three seconds. The Order and Replace lights
will go off.
Light
The Light feature can be used to provide
light to the dispenser area. The light feature
is automatically activated and the indicator
light illuminates. There are two methods available for
lighting the dispenser - Auto and Continous.
The Auto light function activates the dispenser light at
half-power when the light sensor detects that the light
levels in the room are low.
The Continuous light function provides light until
deactivated. The On indicator light will illuminate.
To Activate Auto Light:
Press the Light pad once. The Auto indicator will
illuminate.
Cont.
10