Installation Instructions; Flow Diagram; En Instructions For Use / Assembly Instructions - Hansgrohe AXOR Uno 38113000 Mode D'emploi / Instructions De Montage


Safety Notes
Gloves should be worn during installation to prevent

crushing and cutting injuries.
The shower system may only be used for bathing,

hygienic and body cleansing purposes.
The hot and cold supplies must be of equal pressu-

res.

Installation Instructions

• The fitting must be installed, flushed and tested after
the valid norms.
• If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart
(flow limiter) located behind the aerator can be
removed.
• Hansgrohe mixers can be used together with hydrau-
lically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
Technical Data
This mixer series-produced with EcoSmart
limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:

English
Symbol description
®
(flow
®
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
Assembly see page 31
Do not use silicone containing acetic acid!
Dimensions (see page 33)

Flow diagram

(see page 33)

with EcoSmart
®

without EcoSmart
®
Spare parts (see page 34)
Special accessories
Installation kit order as an extra
Operation (see page 32)
Cleaning
Cleaning recommendations, see enclosed
brochure.
Test certificate (see page 35)