DO NOT DRAPE CORD!
KEEP FROM
CHILDREN!
DESCRIPTION OF THE APPLIANCE:
A. Thermostat knob for setting the temperature
B. Oil temperature light (red, green)
C. Safety micro-switch
D. MIN– MAX level indicators
E. Basket support
F. Viewing window
G. Filter
H. Housing
I.
Handles
J. Slots for fitting the control unit
K. Cover with handle slots
L. Removable bowl
M. Basket with folding handle
N. Electrical heating element
O. Cable compartment
P. Hooks for fastening the control box to the appliance
Q. Thermal safety device reset
R. Control unit
S Oil drain tap
T. Oil drain tap cover
THERMAL SAFETY DEVICE
The appliance is fitted with a thermal safety device that
stops the appliance from heating in the event of incor-
rect use or irregular operation. Once the appliance has
cooled, using a toothpick or similar, delicately press the
safety device reset button "Q" (see Fig. 1). If the
appliance does not start operating again, contact a ser-
vice center authorized by the manufacturer.
WARNING
SERIOUS HOT-OIL BURNS MAY
RESULT FROM A DEEP FAT FRYER
OR COOKER/FRYER BEING PULLED
OFF OF A COUNTERTOP. DO NOT
ALLOW THE CORD TO HANG
OVER THE EDGE OF THE COUNTER
WHERE IT MAY BE GRABBED BY
CHILDREN OR BECOME ENTAN-
GLED WITH THE USER.
DO NOT USE WITH AN EXTEN-
SION CORD.
OPERATING INSTRUCTIONS
Before using the deep fryer for the first time, carefully
clean, using warm water and dishwashing detergent,
the basket, the bowl and the cover. The control unit,
power cable and heating element may be cleaned using
a damp cloth. Check that water does not enter into the
control unit and that there is no residual water in the bot-
tom of the removable bowl. Carefully dry all the parts.
Check that the control unit is properly fastened to the
deep fryer body. The safety micro-switch "C" will not
allow the appliance to be operated if the control unit "R"
is not correctly positioned in the housing "H".
The deep fryer is now ready for use.
FILLING WITH OIL OR FAT
• Remove the cover "K", lifting it by the handle. Turn the
folding handle of the basket until it locks into place
(pos. 2, Fig. 2). Remove the basket "M" by lifting it
upwards.
• Remove the length of cable required to connect the
appliance to the mains, from the cable compartment
"O" (see Fig. 3A). The oil temperature light "B" beco-
mes green.
If your fryer is supplied with magnetic connector:
First connect the magnetic connector (see fig. 3B)
keeping attention to place the connector with the jut
(X) on the bottom side, then connect the plug.
• If oil is used, pour it into the bowl "L" until reaching
the maximum level indicated (see Fig. 4). Never
5