2.When brushroll is rotating,if there are big foreign object
blockage or excessive fiber entangle, or the child
accidentally putting hand into brushroll , the floorhead
will stop working to protect personal safety and avoid
floorhead motor damage.(Please clean up brushroll
in time when big foreign object blockage or
excessive fiber entangle.)
Use of machine stand base
Take out the stand base and place it on the ground.
Align the floorhead with the stand base and put
into the groove of the stand base until machine
stand upright without toppling.(Figure 10)
Attention:when the machine is long idled, place it
in a cool and dry place, avoid direct sunlight or wet
environment to damage hard floor.
Cleaning and Maintenance
Clean Brushroll
According to" Disassemble and assemble to
brushroll" disassemble brushroll and clean brushroll
by hand.After cleaning, assemble brushroll to the
floorhead and continue to use.( Figure 11)
Self-cleaning
1.Take off clean water tank and fill in water containing
cleaning shampoo to the self-cleaning water
line (260mL)(Figure 12)
2.Pour the water in the clean water tank into the
stand base to ensure two slots have water.
3.Plug the charger and put the machine on stand base.
4.Press on/off button and keep pressing water
spray button 5 seconds,indicator turns green.
The brushrolls rotate and machine starts self-cleaning mode.(Figure 13)
5.Self-cleaning mode once for 2 minutes, press any button to stop self-cleaning mode.
6.If there is still foam remaining on brushroll, please start self-cleaning mode again.
7.If brushroll is still not clean after self-cleaning twice, it is recommended to disassemble brushroll for
manual cleaning.
6
10
11
Fill in floor cleaning shampoo
12
and clean water to self cleaning
water line
13
14
Use a screw
driver to insert
into the hole
Slot cutter of mini-brush
to cut off the hair tangled
around brushroll
Pour into
stand base
Connect power
pull out the
handle upward